Lift Rite Ergo-Lift Brochure2

Welcome to interactive presentation, created with Publuu. Enjoy the reading!

Lift-Rite, 5975 Falbourne Street, Mississauga, Ontario L5R3L8 Tel: Toll Free from USA: 1-800-558-6012; Tel: 1-905-456-2603 (Canada and International)

Fax: 1-905-456-1383 Operator’s Manual, Instructions, Parts and Service for Manual and Electric, Publication Number 1130682C ©2013 Dated 08 Oct 2013

OPERATION (CONT.)

Charging the 12 Volt Battery: Move your ERGONOMIC 3000 to a well ventilated area. Raise the

ERGONOMIC 3000 manually and unwind the AC plug from the tie-down inside the bulkhead. Lower the

ERGONOMIC 3000 completely and disconnect the lift plug from the battery connector (located on the side of

the battery box). Insert the charge plug into the battery connector. The lights on the battery charger will indicate

the current battery condition. Plug the AC plug into a 110 volt, 60 Hz receptacle. When your battery is fully

charged, unplug the AC plug from its receptacle, then disconnect the charger plug from the battery plug and

reinsert the lift plug. Carefully raise the ERGONOMIC 3000 and secure the AC cord and the charger plug to the

respective tie-downs inside the bulkhead.

Store the charger power cord in the bracket at all times.

Electric hazard can occur if the plug comes in contact with the battery.

DAILY CHECKLIST

MAINTENANCE

Lubrication: All pivot points in the ERGONOMIC 3000 are equipped with permanently lubricated bushings

and bearings. To increase bearing life, it is recommended that a few drops of light machine oil be applied at

each pivot point every 6 months. The main bearing in the thrust plate is equipped with a grease zerk. This

should be greased every 6 months.

Hydraulic System: Your hydraulic system is maintenance free. Do not add hydraulic oil unless there is, or has

been, a leak. Use Sunoco Sunvis 832 oil or equal. Other oils, fluids, or solvents may damage your hydraulic

system. With the ERGONOMIC 3000 in its lowered position, fill the reservoir through the oil plug hole until the

oil is even with the plug hole.

Battery (12 Volt): Keep the battery water level 1/2 in. (13 mm) above the plates at all times. If it becomes

necessary to add water, use only distilled water. If you suspect that your battery is not charging fully, you can

check your battery acid using a hydrometer. A fully charged battery reads between 1270 and 1275.

CHECK

POINTS

Steering

Hydraulic

System

Wheels

Chassis/

Handle

Lifting/

Lowering

Labels

Batteries (if

equipped)

ACTION

Check full

rotation.

Check for

excessive

oil on

exterior.

Check for

wear,

damage,

and remove

debris.

Check for

damage

and

remove

debris.

Check for

manual

function

and electric

lift (if

equipped).

Check for

readability.

Check for

correct

voltage and

weight, no

leakage, and

battery

disconnect

function.

Made with Publuu - flipbook maker