Big Joe CB33 Specification Sheet
Welcome to interactive presentation, created with Publuu. Enjoy the reading!
3300 lbs. at 24” load center
Compartment: 32.5” x 13.1” x open. An-
derson 175 Gray—A-11 Minimum battery
weight 1050 lbs.
24-volt ZAPI Travel controller, separate�
power steering controller.
Variable from 0 mph to 3.1 mph empty
Variable from 0 mph to 3.4 mph loaded
�º Back �º Forward
Up to 34 fpm empty.
Up to 24 fpm loaded
Up to 27 fpm empty.
Up to 20 fpm loaded
TIRES / WHEELS
10” x 4.1” polyurethane
10” x 4” polyurethane
Lift cylinder is hard chrome. Pump unit
includes motor, gear pump, and solenoid.
Pressure compensated lowering valves
regulates lowering speeds.
Infinelty variable travel controller and AC
drive motor provides high torque through-
out the entire drive range. Regenerative
braking and brushless design drastically
Travel speed remains constant relative to
throttle position regardless of the load on
truck. Automatic resetting circuit breaker
and one piece micro switch design com-
plete the system.
Electromagnetic brake is mounted on mo-
tor armature shaft multiplying the braking
power through the ZF GK20 transmission.
Brake is applied when control arm is in the
vertical or horizontal handle position.
Travel speed is reduced when forks are
above 12” fork height. Neutral braking re-
sists roll back on ramps.
Travel, lift, lower and tilt functions are
located in the ergonomic operator handle,
designed to allow operation with either
hand. Wrap around guard, reversing
switch, thumb control, and horn are stand-
Vertically mounted drive motor is direct
mounted to gear housing. Oil bathed ZF
GK10 hypoid bevel gear drive-train
transfers power to axle. State of the art
optimized gear technology supplies
advantages such as minimal envelope
circle, zero maintenance, low noise level,
high efficiency and high performance.
FRAME AND MAST
Bolt-on high visibility I-beam construction,
lift cylinders are positioned in outer I-
beam. Dual lifting chains. Class two ITA
fork carriage with 36” tall load back rest.
sealed in oil bath
LOAD WHEELS-Sealed ball bearings
Removal of two piece power head cover
exposes major components for inspection
and maintenance. Drive wheel is removed
with one nut.
Regenerative Neutral Braking
Gas Assist Spring Handle
Low Battery Lift Interrupt
Hour Meter BDI Combo Gauge
35” Tall Load Backrest
4-Pack Battery Pack
3300 Lbs. Capacity
Power Drive Counterbalance Stackers
Big Lift LLC
All units are built to be in compliance with the Occupational Safety & Health Act (OSHA)
Big Lift LLC will not assume liability for injuries or damage arising from, or caused by, the removal of any safety devices from their vehicles by user. Because of
the Big Lift LLC continuing product improvements, specifications are subject to change without notice.
© Copyright 2015, Big Lift LLC Printed USA 0415
3300 Capacity @ 24" Load Center ITA Class II Fork Carriage
Aisle dimensions listed above assume 4” be-
tween loads. Use the larger dimension; load
width or load length. For ease of use and add 6”
to 12” for operator clearance to the appropriate
specifications listed above. Truck performance
may vary due to application requirements' and
changes in model design.
CB33 - Right Angle Stacking
For ease of use add 6 to 12” to aisle dimension listed
³ Estimated shipping weight without battery
*Derate 500 lbs. above 132”