BigJoe-WPT45-PartsList

Welcome to interactive presentation, created with Publuu. Enjoy the reading!

BG-WPT-0610

2-1

SECTION 2

OPERATION

2-1. GENERAL.

This section gives detailed operating instructions for

the WPT 45 lift truck. The instructions are divided into

the various phases of operations, such as operating

lift, driving, and stopping. Routine precautions are

included for safe operation.

2-2. OPERATING PRECAUTIONS.

WARNING: Improper operation of the lift truck may

result in operator injury, or load and/or lift

truck damage. Observe the following

precautions when operating the WPT 45

lift truck.

The following safety precautions must be adhered to

at all times.

• Do not operate this truck unless you have been

trained and authorized to do so and have read all

warnings and instructions in this manual and on the

truck.

• All warnings and instructions must be read and

understood before using the equipment.

• Equipment must be inspected by a qualified person

on a regular basis.

• Do not operate this truck until you have checked its

condition. Give special attention to Tires, Horn, Bat-

teries, Controller, Lift System, Brakes, Steering

Mechanism, Guards and Safety Devices

• Operate truck only from designated operation posi-

tion. Wear foot protection. Do not carry passengers.

• Observe applicable traffic regulations. Yield right of

way to pedestrians. Slow down and sound horn at

cross aisles and wherever vision is obstructed.

• Start, stop, travel, steer and brake smoothly. Slow

down for turns and on uneven or slippery surfaces

that could cause truck to slide or overturn. Use spe-

cial care when traveling without load as the risk of

overturn may be greater.

• Always look in direction of travel. Keep a clear view,

and when load interferes with visibility, travel with

load or lifting mechanism trailing.

• Do not overload truck. Check nameplate for load

weight and load center information.

• Before lifting, be sure load is centered, forks are

completely under load, and load is as far back as

possible against load backrest.

• Do not handle loads which are higher than the load

backrest unless load is secured so that no part of it

could fall backward.

• When leaving truck, neutralize travel control. Fully

lower lifting mechanism and set brake. When leaving

truck unattended, turn off key switch and disconnect

switch, remove key and disconnect battery.

2-3. BEFORE OPERATION

Table 2-1 covers important inspection points on the

WPT 45 lift truck which should be checked prior to

operation. Depending on use, some trucks may

require additional checks.

Figure 2-1 shows a sample format for an Operator

Checklist, which can be modified as necessary to fit

your operation.

WARNING: Periodic maintenance of this truck by a

QUALIFIED TECHNICIAN is required.

CAUTION:

A QUALIFIED SERVICE TECHNICIAN

should check the truck monthly for

proper lubrication, proper fluid levels,

brake maintenance, motor maintenance

and other areas specified in the SEC-

TION 3.

WARNING: If the truck is found to be unsafe and in

need of repair, or contributes to an

unsafe condition, report it immediately to

the designated authority. Do not operate

it until it has been restored to a safe

operating condition. Do not make any

unauthorized repairs or adjustments. All

service must be performed by a qualified

maintenance technician.

Made with Publuu - flipbook maker